Use: accurate processing unit adjustment and positioning for product format changeover, with manual drive. The compact dimensions and customisable length make this linear table suitable when rigidity and reduced dimensions are required, silent and low-cost.
State of supply 2 sliding shafts in hardened, ground and chrome-plated CF53 steel (or in AISI431 stainless steel on request) on bronze-coloured anodised aluminium profile; 2 heads in anodised aluminium silver; 4 polyethylene screw caps ; 4 UNI5939 M6x50 fastening screws in galvanised steel; 1 silver-coloured anodised aluminium carriage with 4 gothic arch rollers in steel and magnets for limit switches; 1 screw with trapeze threading in stainless steel AISI 304; lead nut in technopolymer; remaining nuts and bolts in galvanised steel.
worm screw, Tr16 pitch 4 (1 turn = 4 linear mm).
Positioning accuracy: ±0.3 mm/300mm*
Carriage axial backlash: 0.15 mm
Standard pack: 1 piece.
Operation: STEP-BY-STEP (NO continuous operation).
Max. 120 rpm; max time: 1 min; on/off ratio=1/10 (10%)
* the ACCURACY indicated is theoretical. Accuracy levels depend on the actual conditions of use and are affected by the accuracies of the kinematic chain - consisting of the handwheel/crank handle/revolution counter kit or any connection joints - and by the performance of the position control system (encoder, etc.).
|Order code||LG mm||LC mm||C mm||Cx N||Cy N||Cz N||Mx Nm||My Nm||Mz Nm||Weight kg||Stock||€ piece||Buy||Draw|
|Customisations On request LG, LC and C; sliding shafts and rollers in stainless steel|
Products not in stock minimum order 1 piece, delivery in 20 days (unless stock runs out).