With safety switch for inside/outside fastening

Use: applicable both on stainless as well as aluminium tubes when a safety switch is required.

Material reinforced polyamide hinge, stainless steel pin, switch nylon mount, stainless steel nuts and bolts, polyethylene end caps, safety switch in thermoplastic material.

State of supply hinge complete with 8x131.5 ø pin, switch mount, Bernstein I88- AHDB 180° safety switch, 1 3x14 elastic pin, 2 M6x10 socket head screws, 2 M6x20 socket head screws, 2 M6 washers, 2 end caps, 2 M4x10 hex. socket countersunk head screws, 2 M4x25 socket head screws, 2 M4 washers., 1 3.5x12 elastic pin.

Characteristics: as an alternative to Part 1800, to be used in cases where the hinge cannot be fastened inside the structure and therefore needs to be fastened on the front.

The switch head can be turned with respect to the body in order to construct doors with RH or LH opening sensors with the same order code.

Note: for further information on the product, please request the relative technical manual sheet.