![]() ![]() |
Use: it allows adjusting the height of the control contact lever unit in order to detect the product flow. The basic version is ideal if you need the system to move the control contact levers and relative bars and fastening brackets. State of supply Kit complete with 2 idler jacks with reduction gear body in RAL9005 black reinforced polyamide; 1 brake with tightening wing nut in RAL3020 red reinforced polyamide (wing nut cap in RAL9005 black, 1 knob fastened with a UNI5739 M6x12 hex head screw and washer for M6 screw, 1 screw cap in RAL3020 red polyamide), 2 racks, 2 gea rwheels in neutral polyamide, 1 hexagonal synchronisation and transmission shaft 16, 8 UNI5739 M6x55 hex head screws, 8 UNI7474 M6 self-locking nuts, 16 M6 screw washers. Material version Dry environment Z Racks, hexagonal shaft and nuts and bolts in galvanised steel. Material version Wet environment B Racks in steel with chemical nickel-plating (thickness 10÷15 µm), hexagonal shaft in AISI303 stainless steel, stainless steel nuts and bolts. WET Characteristics: the synchronised movement of the two jacks occurs by means of the hexagonal synchronisation and transmission shaft. Permanent setting is assured by a brake that prevents any loss of position caused by external factors (e.g. vibrations). Warning: in order to protect the internal transmission devices, if you use the knob for movement, the brake will not fully lock the position. Maintenance: not required. Standard pack: 1 piece.
Nominal torque transmissible 12 Nm (4.5 Nm version on request). Rack's travel per turn: 1 knob turn = 128 mm of rack travel.
STEP-BY-STEP (NO continuous operation). On/off ratio=1/30 Maximum uninterrupted operation: 1 min. operation; Manual drive. |
QUANTITY DISCOUNT
Qty | 1+ | 2+ | 4+ | 8+ |
Discounts | - | -5% | -10% | contact us |